Newbie here :)
I just noticed that Zebra 2 oscillators have a strange modulation.
I just have the simplest patch with only an osc1 and I mounted an oscilloscope to see the waveform. The oscilloscope confirmed what I was hearing: the waveform changes over about 0.5 Hz cycles.
It is as if there is another waveform at 0.5 Hz from my pitch, and this creates in-phase out-of-phase interferences over these cycles. With Saw/Square etc, this radically changes the sound. With Sine the destructive interference is total, so this creates silence cycles.
Can you help me solve this problem and get the waveform that I want from my osc?
Submitted October 30, 2016 at 08:20AM by friedaubergines https://www.reddit.com/r/edmproduction/comments/5a5lfu/zebra_oscillator_unwanted_modulation_help/?utm_source=ifttt