So I recently purchased a sub pac, absolutely love it its amazing.
However I'm trying to incorporate it into my mobile setup which is:
Laptop, Focusrite audio interface, Seinhessier 650 HD's, Sub Pac
The focusrite has 1 headphone output, and 2 main outputs (L,R). My headphones go out of the headphone out and I'm trying to run the sub pac out of one of the Main outs, but It won't recieve or play back any of the audio coming from either out. I'm assuming its because it needs a mono signal? I put the sub pac in the headphone out and it worked fine then.
Should I get a 2 -> 1 1/4in TRS Y cable to combine the 2 outs to the sub pac? I'm stumped.
How do I go about combining these elements. Thank you.
Submitted December 01, 2016 at 09:51PM by johnsahhar https://www.reddit.com/r/edmproduction/comments/5g09xl/using_my_sub_pac_w_an_audio_interface/?utm_source=ifttt
Javier Rodriguez
Thursday, December 1, 2016