I was reading the manual and it says that you can set the ratio to 0 and use negative offset values to control the phase of the waveform. Can someone explain how this can be used? I'm assuming an oscillator with this setting would be used as a modulator because it produces nothing audible, but I don't notice any effects on the carrier signal either.
Submitted October 04, 2017 at 10:53PM by mt2043 https://www.reddit.com/r/edmproduction/comments/74cwvl/can_someone_explain_the_static_wave_shaper_in_fm8/?utm_source=ifttt
Javier Rodriguez
Wednesday, October 4, 2017