Sorry if my question doesn't make sense.
For example, after correcting phase problems, I have a layered synth bass with positive (+1) phase correlation from both 100% mono AND mono/stereo mix. However, when I check JUST the stereo output (no mono signal), the correlation meter goes into negative (-1). Should I also make sure to align the phase of the stereo output, and if so, what are some ways to go about this?
Thanks for any advice!
Submitted February 20, 2017 at 03:09PM by stopitdouchebag https://www.reddit.com/r/edmproduction/comments/5v641n/should_i_care_about_the_phase_correlation_of/?utm_source=ifttt